Loading... Please wait...
  • My Account 

Currency Displayed in

Sole Guard 160cc

Hover over image to zoom

  • Vettec Sole Guard
Sorry, this product has been discontinued

 Product Description

Sole-Guard™ is the first product of its kind to offer fast and effective protection and support for the unshod foot. Simply fill the bottom of the foot with Sole-Guard creating a protective coating that bonds to the foot for three weeks. Sole-Guard sets firm to protect the unshod foot, but retains flexibility to move naturally with the foot, providing comfort and support. Sole-Guard provides complete protection and support in on easy application. Contact your dealer or Vettec today to see how Sole-Guard can work for you.


1.Trim and conservatively pare the sole. With hoof knife trim and clean the frog, bars and commisuers.

2.DRY HOOF THOROUGHLY using a heat gun or hair dryer, even if you don’t think it needs it. Don’t overheat.

PROCEDURE 1 - When working on level surfaces

1.Immediately after drying, hold the hoof as flat and level as possible.

2.With the frog turned upward, dispense Sole-Guard and fill in the sole until the desired level is achieved.

3.This is usually just short of the white line. Do not fill above the level of the wall.

4.Place plastic sheet over sole and smooth to desired effect.

5.Hold the hoof for approximately 1 minute, then release.

6.Remove plastic sheet in approximately 5-6 minutes.

PROCEDURE 2 - When working on soft or uneven surfaces1.After drying; hold the hoof and dispense Sole-Guard alowing material to flow towards toe.

2.Apply a foam board to the toe region first and lay the board towards the heel leveling the Sole-Guard material.

3.Hold for one minute and set the foot down.

4.Remove foam board after 6 minutes.

EMERGENCY/TRAIL RIDING ROCEDURES1.Wire-brush the sole and frog removing all dirt and debris.

2.Dry the sole and frog using clean rag or towel.

3.Apply as above using either method 1 or 2.


All Vettec products are now 160cc rather than 180cc. The new size 160cc cartridges are 100% compatible with 180cc Vettec guns, tips and other products.

 Product Videos

Vettec Sole-Guard Unshod Foot
  • Vettec Sole-Guard Unshod Foot
    Properly apply Sole-Guard to an unshod foot.
  • Vettec Sole-Guard Product Introduction
    Learn what Sole-Guard is used for
  • Vettec Sole-Guard Prep Technique
    Properly prepare the hoof for a Sole-Guard application

 Find Similar Products by Category

You Recently Viewed...


What's News

Follow us on


Copyright 2019 Farrier Shop. All Rights Reserved   |   All prices NZD and exclude GST   |